|
| | |
|
|
kingjim9
User
Aug 12, 2008, 5:08 PM
Post #1 of 6
(2119 views)
|
|
Advice on Speakers
|
Sign In
|
|
I have an aftermarket JVC 50W x 4 MOSFET CD Player installed in my car. Here's some specs on it: (Maximum Watts per Channel 50W x 4, RMS Wattage 20W x 4, Amplifier Type MOSFET, CD Signal to Noise Ratio dB 98dB)
I'm currently looking to buy new speakers for my car. I was wondering if anybody had any advice on which brands to get.
I was looking at some Sony speakers... Here's some specs on those: Handles up to 190W peak power (40W RMS) 6-3/8" HOP (Highly Oriented Polypropylene) woofer cone offers high rigidity and minimal resonance for full, deep bass 1-7/16" H.D.L.D. (High Density Layered Diaphragm) tweeter provide crisp, dynamic highs Ferrite magnet structure Frequency response: 30Hz - 25kHz Sensitivity: 91 dB/W/m Impedance: 4 ohm Bottom mounting depth: 1-3/4" Cutout diameter: 6-1/4"
Also I'm only buying the Front Speakers right now and will probally buy rear ones closer to the end of the year, I don't think this would be an issue though (unless someone thinks otherwise)
Any Advice would be greatly appreciated!
Thanks,
Jim
|
|
| |
|
|
DrElectrics
Enthusiast
Aug 21, 2008, 3:14 PM
Post #2 of 6
(2059 views)
|
Re: Advice on Speakers
|
Sign In
|
|
I will give you a glimpse of my system specs. I have won many a "sound off" with my system but I have put a lot of crazy time and money into it. But basically your system needs to refelct the music you listen to. I listen to hip hop and rock. I am running 2 x Pioneer 8" round 4 way 150W speakers in the front. They are a deep fit which means they need a pod behind them in the door to allow extra room for the magnet to fit. I am running the same in my back door speakers, then for my rear shelf speakers I have Kenwood 7 x 10 4way 250W. HUGE bass in them. I then have 2 sony explode 12 inch subs running off a sony 4channel 2000 WATT amp, I have the same style amp under my passenger seat running the front and back door speakers, but only 1500W. Then I have a BOSS 2 channel amp 500W with sub control running my rear shelf speakers. I change the sub control depending on what music I am listening to.
Hope this helps
|
|
| |
|
|
kingjim9
User
Aug 31, 2008, 5:15 PM
Post #3 of 6
(2025 views)
|
|
Re: Advice on Speakers
|
Sign In
|
|
Could you recommend a set of speakers that wouldn't require amps and a sub. I'm trying to keep the cost down and don't want to be buying an entire system. I listent to mainly rock and classic rock.
|
|
| |
|
|
DrElectrics
Enthusiast
Sep 3, 2008, 7:47 PM
Post #4 of 6
(2007 views)
|
|
Re: Advice on Speakers
|
Sign In
|
|
Easy one, Either Pioneer or Alpine do a great crisp 4 way 6x9 speaker, pref 150-220Watts. The bass cone is not too deep, therefore you will get more of a crisp sound from you tweeters and mid pitch. Good for rock especially for the fact you can hear guitars and singer nicelty and get a faint but still decent kick when the drummer is putting time in. That's my suggestion.
Good luck
|
|
| |
|
|
kingjim9
User
Sep 4, 2008, 11:19 AM
Post #5 of 6
(2002 views)
|
|
Re: Advice on Speakers
|
Sign In
|
|
The only 6" x 9" I found that fit a '00 Dodge Neon are both 3 way:
Alpine - Type-S 6" x 9" 3-Way Coaxial Car Speakers with Poly-Mica Cones - Handles up to 260W peak power (85W RMS)
- 6" x 9" poly-mica woofer cones with high-grade strontium magnets and Santoprene surround deliver rich, deep bass; stamped steel frame for high rigidity and minimal resonance
- 1" wide-range silk soft-dome and 5/8" dome tweeters with ultralow distortion magnets for crisp, expressive highs; tweeters swivel up to 10° for custom positioning
- Frequency response: 65Hz - 23kHz
- Sensitivity: 90dB/W (1m)
- Impedance: 3.6 ohms
- Mounting diameter: 5-15/16" x 8-3/4"
- Mounting depth: 3"
Pioneer - 6" x 9" 3-Way Car Speakers (Pair) - Handles up to 250 watts peak power (40 watts RMS)
- 6" x 9" woofer cone uses KEVLAR fiber for deeper bass
- 2-1/4" soft dome midrange cone provides fast response for clean sound
- 3/4" polyester fiber soft dome tweeter for crisp high-frequency response
- Butyl rubber woofer surround
- Impedance: 4 ohms
- Cutout diameter: 8-7/16" x 6-1/4"
- Bottom mount depth: 2-1/2"
What difference would the lack of the 4th channel create?
|
|
| |
|
|
DrElectrics
Enthusiast
Sep 25, 2008, 3:06 PM
Post #6 of 6
(1963 views)
|
|
Re: Advice on Speakers
|
Sign In
|
|
I would go the Apline for your style of music. They have a well crafted crisper mid pitch and tweeter with a nice crisp kick from the bass cone. The Pinoneer is a little deeper with the bass tone, still crisp with eht mid pitch, but tweeter is there for looks not performance in some cases. The 4 way is used to seperate the higher sounds into 2 channels instead of one. You will have 2 tweeters, 1 mid, 1 bass cone. It is just a more distinguished sound as they dedicate 2 tweeters instead of 1. But I would roll with the Alpine.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
