Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









2007 mazda 6 windows


Search for (search options)
 



stretchy
New User

Jul 24, 2012, 10:38 AM

Post #1 of 4 (3187 views)
  post locked   2007 mazda 6 windows  

my '07 mazda 6 had its battery fried the other day because of the heat outside. I replaced the battery and its all working now except the power windows, the passenger window control on the driver side no longer works and the automatic option on the passenger window no longer works either (in other words i can open the window only by using the passenger control and the auto option does not work)

of course everything worked fine before the battery died.

when the battery died I tried starting the car a few times before i realised it was no use and the fuse box started to click (Short circuit im assuming) when i tried to start it with the dead battery

my only assumption is that the fried battery + my attempt at starting the car cooked some wires and now i must get them replaced?

please help :)

Devon


stretchy
New User

Jul 24, 2012, 11:44 AM

Post #2 of 4 (3166 views)
  post locked   Re: 2007 mazda 6 windows  

im now starting to think that i need to reset my windows, any opinions?


stretchy
New User

Jul 24, 2012, 12:00 PM

Post #3 of 4 (3161 views)
  post locked   Re: 2007 mazda 6 windows  

success!!

This is the procedure that worked for me for anyone with similar problems

This is a quote from the workshop manual

Note
? A driver side window will not fully close automatically under following the conditions:
? The battery has been disconnected during vehicle maintenance or for other reasons.
? The power window main switch connector, or driver-side power window motor connector has been
disconnected.
? Carry out the following procedure to resume operation:
1. Turn the ignition switch to the ON position.
2. Press the driver side power window main switch and fully open the driver side window.
3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window,
and keep holding the switch up at the position for about 2 seconds to complete initial setting.

TWO-STEP DOWN FUNCTION OPERATIVE/NON-OPERATIVE SWITCHING PROCEDURE

Note
? By following the procedure below, the two-step down function is switched to non-operative when it is
operative, and to operative when it is non-operative.

Turn the Ignition on
Within 5 sec
perform the auto open two times
perform the auto close two times

turn the ignition off and within 40 seconds and repeat the above sequence.

Repeat for all the windows.


Discretesignals
Ultimate Carjunky / Moderator
Discretesignals profile image

Jul 24, 2012, 12:40 PM

Post #4 of 4 (3155 views)
  post locked   Re: 2007 mazda 6 windows  

Just getting ready to post that. Glad to see you figured it out. Thanks for the follow upSmile





Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.






 
 
 






Search for (options) Privacy Sitemap