Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









Turning signal!


Search for (search options)
 



loganm1983
New User

Jan 25, 2009, 3:24 PM

Post #1 of 5 (1763 views)
Turning signal! Sign In

1994 Oldsmobile 88 Royale 73000 miles

When I engage my right tuning signal it no longer blinks but stays on solid until disengaged. Used to work fine but I don't know if this -20 F wheather in Iowa is taking its toll on my car...Unsure


Loren Champlain Sr
Veteran / Moderator
Loren Champlain Sr profile image

Jan 25, 2009, 3:40 PM

Post #2 of 5 (1761 views)
Re: Turning signal! Sign In

Logan; Of course, the first thing to do is check to make sure the outside lamps are working. It's not uncommon for 1/2 of the turn signal flasher to take a dump. The four-way flasher and the turn signal flasher are two different units and are identical. The four way is usually the one plugged into the fuse box. The turn signal flasher is usually 'hidden' under the dash, usually on the driver's side. If one side blinks, you can turn it on that side and listen for the click to locate it. Then, just swap the flashers to confirm.
Loren
SW Washington


loganm1983
New User

Jan 26, 2009, 6:56 PM

Post #3 of 5 (1747 views)
Re: Turning signal! Sign In

OK I have an update, i thouroughly checked all signal lamps. When I turn on the hazards everything works fine. Left turning signal front and back lamps work fine. The right turning signal gives me nothing in the front and back lamps. And when right signal is engaged the dash light stays lit solid.


(This post was edited by loganm1983 on Jan 26, 2009, 6:58 PM)


Loren Champlain Sr
Veteran / Moderator
Loren Champlain Sr profile image

Jan 26, 2009, 7:16 PM

Post #4 of 5 (1741 views)
Re: Turning signal! Sign In

Have you checked the flasher, yet? Neither front or rear right turn signal blinks with turn signal, correct? Still sounds like a flasher problem. It's possible that it could be the switch, but need to eliminate the flasher, first.
It's only happened to me a couple of times, but could be a faulty bulb, where one filiment is lying across the other. Drove me nuts, the first time. So, inspect the bulbs carefully, too.
Loren
SW Washington


bruceg
User

Jan 28, 2009, 2:11 PM

Post #5 of 5 (1730 views)
Re: Turning signal! Sign In

turn signals are run in series, front to back, if you have a bulb that is bad on one side, it is possible to loose everything on the front and back of the vehicle, check all the bulbs, front and back to see if one is blown, if all are good, then replace your flasher, but probably a bad bulb.






 
 
 






Search for (options) Privacy Sitemap