|
|
Hanksix
Novice
Apr 22, 2023, 4:27 PM
Post #1 of 14
(1966 views)
|
I have a 2002 Chevy Malibu 6cyc. I've done the test and have a draw of 1.7amps. Removed Maxi Fuse 2 (30amp) drop loss to .80 amps, removed Maxi Fuse 3 (30amp) draw dropped to .01. Manual states #2 fuse = right electrical center-fog lamps, radio, body function control mod, interior lamps. #3 fuse= left electrical center-stop lamps body function control mod. cluster climate control system. removed all fuses, one at a time from left side compartment, no change, also right side, no change in power draw. All fuses intact all accessories are working, what next? Thank you
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Apr 22, 2023, 7:24 PM
Post #4 of 14
(1925 views)
|
|
Re: parasitic draw
|
Sign In
|
|
You didn't expire the timers so the testing is invalid.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Hanksix
Novice
Apr 27, 2023, 1:30 PM
Post #5 of 14
(1847 views)
|
|
Re: parasitic draw
|
Sign In
|
|
Mr. Hamertime. I did the re-set as you outlined in your first post and found the body function control module, left side interior fuse box, to be the culprit. Replacement mods require flash programing or vehical specific on car programing must be performed to function. Is this something a shade tree mechanic can do or do I need a shop to do this? Thanks again for the guidance..
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Apr 27, 2023, 1:35 PM
Post #6 of 14
(1842 views)
|
|
Re: parasitic draw
|
Sign In
|
|
If in fact you replace this unit you will need dealer level equipment to program it.
I hate to burst your bubble but the BCM itself may not be at fault. There are many functions that run through the BCM that could be causing the draw through the BCM.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Apr 27, 2023, 2:08 PM
Post #7 of 14
(1836 views)
|
|
Re: parasitic draw
|
Sign In
|
|
What did you do to determine it was the BCM itself and not some other load controlled by the BCM?
How fast does the battery go dead, is it overnight or does it takes a few day to run down?
What is the current draw after all the modules time out/go to sleep?
|
|
| |
|
|
Hanksix
Novice
Apr 28, 2023, 10:46 AM
Post #8 of 14
(1808 views)
|
|
Re: parasitic draw
|
Sign In
|
|
replying to both, I drew down the mods, caps, by jumping the + and - batt. cables while off the battery for 1 hour. Re-connected the + side pulled the - placed amp meter neg lead to battery - positive lead from amp meter - battery post. Amp draw 1.7. started removing fuse's first from the paasenger side box then drivers side until draw dropped to .01 amps when pulling BCM BATT fuse 10amp from driver side. The battery goes dead after about 24+ hours,
|
|
| |
|
|
Hanksix
Novice
Apr 28, 2023, 11:21 AM
Post #9 of 14
(1802 views)
|
|
Re: parasitic draw
|
Sign In
|
|
I have no other issues with regard to the BCM. All accessories work as they should
|
|
| |
|
|
Hanksix
Novice
Apr 28, 2023, 1:09 PM
Post #11 of 14
(1782 views)
|
|
Re: parasitic draw
|
Sign In
|
|
you got me confused now. I need to leave the jumper in place between the + and - cables while off the battery , then hook up the amp meter to the - cable and - battery post, then start pulling fuses???
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Apr 28, 2023, 1:13 PM
Post #12 of 14
(1777 views)
|
|
Re: parasitic draw
|
Sign In
|
|
Yes, you leave the jumper for the expiration period while the meter is also hooked up so when you remove the jumper, the meter is already turned on and in place. A disconnect of even a split second starts everything all over again.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Hanksix
Novice
Apr 29, 2023, 6:12 PM
Post #13 of 14
(1746 views)
|
|
Re: parasitic draw
|
Sign In
|
|
Thanks for your help. I think I got it fixed. 72 hrs without a need for a charge.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Apr 29, 2023, 6:14 PM
Post #14 of 14
(1742 views)
|
|
Re: parasitic draw
|
Sign In
|
|
What did you do to fix it?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
