|
|
1991 Toyota 4Runner Engine issues
|
|
|
| |
|
supbrosef
New User
Dec 13, 2012, 3:20 PM
Post #1 of 5
(3387 views)
|
1991 Toyota 4Runner Engine issues
|
Sign In
|
|
1991 Toyota 4Runner 6Cylinder, 173,000 miles The check engine light went on in my car when i turned onto the main street this morning. the car was accelerating really slow. it did this the whole way until i got where i needed to be. i had the car turned off for only about 10-15 minutes. when i started it back up, everything was fine and back to normal. it did this for the first time last week, but didnt think anything of it. -havent changed the transmission oil in a long time -the temperatures were fine while driving
|
|
| |
|
nickwarner
Veteran
/ Moderator
Dec 13, 2012, 3:24 PM
Post #2 of 5
(3381 views)
|
Re: 1991 Toyota 4Runner Engine issues
|
Sign In
|
|
Your check engine light is on because there are codes stored in the ECM. You need to get access to a scanner that can read the codes and post them here. I know the OBD-1 GM cars you could get the codes without a scanner, but I'm not too familiar with the older Toyotas. Maybe one of the other mods here knows some more info on that than I do.
|
|
| |
|
supbrosef
New User
Dec 13, 2012, 3:34 PM
Post #3 of 5
(3367 views)
|
Re: 1991 Toyota 4Runner Engine issues
|
Sign In
|
|
yes but the light wasnt on when i turned me car back on. everything ran fine again once it was off for 10-15 minutes.
|
|
| |
|
supbrosef
New User
Dec 13, 2012, 3:48 PM
Post #4 of 5
(3358 views)
|
Re: 1991 Toyota 4Runner Engine issues
|
Sign In
|
|
i think i found out how to check without a scanner link deleted ........................ not allowed, it was for GM anyway but will it still work since the check engine light is not on right now?
(This post was edited by Hammer Time on Dec 13, 2012, 4:36 PM)
|
|
| |
|
Discretesignals
Ultimate Carjunky
/ Moderator
Dec 13, 2012, 5:33 PM
Post #5 of 5
(3331 views)
|
Re: 1991 Toyota 4Runner Engine issues
|
Sign In
|
|
Need to go under the hood and find the diagnostic port. Flip the cap up and there will be a diagram underneath. Take jumper and jump TE1 to E1. Then turn on the ignition. The check engine light will flash the codes. Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|