|
| | |
|
|
tacmale
New User
Mar 30, 2007, 3:18 PM
Post #1 of 5
(5841 views)
|
|
1994 Pontiac Grand Prix
|
Sign In
|
|
I have a 1994 Pontiac Grand Prix that used to stall after driving for a while or if left idling. Replaced the fuel filter, fuel pump, fuel pressure regulator, Ignition Control Module, plugs, wires, and fuel pump relay. Now it will start for about 3 seconds then just dies. Was wondering if it could be either the crankshaft or the camshaft position sensors. Any help would be greatly appreciated.
Need to add when i run an obd check no codes show up.
I realized i did not give very good info, here is a list of things i have replaced or tested on the motor. It is a 3100 SFI I have to work in the open and live in Washington and have to do this between rain stroms.
Fuel pressure-good
Fuel pump relay-replaced
fuel pump-replaced
fuel pressure regulator-replaced
ICM-replaced
Plugs and wires-replaced
engine has spark and fuel or so it appears it wants to start afetr disconnecting the battery and leaving it sit to clear the memeory. Starts for just a few seconds then acts like the timing is off tries to start but backfires once in a while. But just cranks over, battery has full charge.
(This post was edited by tacmale on Apr 14, 2007, 4:44 PM)
|
|
| |
|
|
steve01832
Veteran
Apr 1, 2007, 7:23 AM
Post #2 of 5
(5826 views)
|
|
Re: 1994 Pontiac Grand Prix
|
Sign In
|
|
You should start with checking the fuel pressure with a guage. It is possible that the fuel pump relay is pulling in during key on engine off but may not be getting a signal after the engine fires causing it to die. Key on engine off fuel reading should be around 35 psi. If this is ok then start the engine and let it stall. Check the guage. If it is holding at 35 psi the fuel delivery is ok. If the guage is way down, check for spark at the plugs and check for injector pulse by installing a noid light into one of the injector connectors. If there is no spark and no injector pulse, replace crank sensor. If there are different symptoms, post back with the results and we can go further.
Steve
|
|
| |
|
|
whitey79
User
Apr 7, 2007, 9:09 PM
Post #3 of 5
(5810 views)
|
|
Re: 1994 Pontiac Grand Prix
|
Sign In
|
|
i assume its a quad 4? my lil sister had one and i had to replace the cps, and the plug wire assembly(sorry i forgot what the deal is called the holds the plug boots. i cleaned it also). the camshaft position sensor was a real pain in the rear to replace. i would reccomend doing it in a garage. if you have to.
like a rock my arse...chevys for life
|
|
| |
|
|
tacmale
New User
Apr 15, 2007, 4:10 PM
Post #4 of 5
(5772 views)
|
|
Re: 1994 Pontiac Grand Prix
|
Sign In
|
|
finally got some dry weather to work in i got no fuel pressure when it placed my gague on it. I have replaced the fuel pump relay and the fuel pressure regulator and a new fuel pump. Still no pressure reading. I tried squirting gas in thru the throttle body but even that didnt start it.
(This post was edited by tacmale on Apr 15, 2007, 4:11 PM)
|
|
| |
|
|
tacmale
New User
Apr 21, 2007, 10:10 AM
Post #5 of 5
(5757 views)
|
|
Re: 1994 Pontiac Grand Prix
|
Sign In
|
|
Went to check the crankshaft position sensor which on the 3100 sfi v-6 is located on the firewall side of the engine. I noticed the wire way down looked burned. Got a light and sure enough the clip holding it had come loose and the wire had fallen on the exhaust and burned thru. Simple fix, just had to rotate the motor and get at the sensor from the front of the engine. Thanks for all the help guys got me going in the right direction.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
