|
|
|
2005 Mitsubishi Lancer Ralliart
|
|
|
| |
|
|
AirborneGeekRanger
New User
Jul 4, 2012, 8:51 AM
Post #1 of 9
(4015 views)
|
2005 Mitsubishi Lancer Ralliart
|
|
|
2005
Mitsubishi
Lancer
2.4L 4cyl 5M
140,000 Miles
Standard Transmission
2 Wheel Drive
No Aftermarket Add-ons
ALL Scheduled and Regular Maintenence Performed
1 Family Owned
Hello,
When driving at any speed and actively pressing on the throttle the car performs stellar. When I let off the throttle or keep the throttle at a steady speed, the car sporadically feels like it has a loss of power and then resumes. It feels as if a huge gust of wind hits me. In the past I have had the CEL come on and then go away after a full tank of gas has been used. This has happened at least 3 times in a year or two. The only recent thing done to the vehicle has been charging the Air Conditioner. I thought the compressor was the culprit, but this problem happens with or without A/C running. I have done the following to rectify the current problem with zero success.
- Changed the Spark Plugs (Not the cheapest ones, but not NGK's) Gapped at .044 per Autozone tech and manual
- Used premium STP Fuel Injector Cleaner in the gas tank with a full tank of gas.
- Changed Air Filter.
- Oil and Filter changed.
- Purchased throttle body cleaner and sprayed the outside of the throttle body (Thinking the cable might be seized up)
I am grateful for any suggestions and appreciate you taking the time to lend your expertise.
|
|
| |
|
| | |
|
|
AirborneGeekRanger
New User
Jul 4, 2012, 9:27 AM
Post #3 of 9
(3993 views)
|
|
Re: 2005 Mitsubishi Lancer Ralliart
|
|
|
The CEL has come and gone several times. I attributed it to bad gas. The current problem has presented itself only recently and is still here. I did not have a code reader hooked up to the vehicle when the CEL light came on because it went away after a full tank of gas had been used. I will take it to Autozone today and see if any codes come up.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jul 4, 2012, 9:34 AM
Post #4 of 9
(3983 views)
|
|
Re: 2005 Mitsubishi Lancer Ralliart
|
|
|
The more information you can get, the better chance you may have formulating a strategy to figuring out where to look for the culprit.
Even though the light may have gone out. The engine controller can store the code(s) in history.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
AirborneGeekRanger
New User
Jul 8, 2012, 3:01 PM
Post #6 of 9
(3915 views)
|
|
Re: 2005 Mitsubishi Lancer Ralliart
|
|
|
P0335 Crankshaft Position Sensor A Circuit Malfunction
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jul 8, 2012, 3:05 PM
Post #7 of 9
(3911 views)
|
|
Re: 2005 Mitsubishi Lancer Ralliart
|
|
|
Yes, that helps a lot. The computer is seeing an issue with the Crank Sensor signal. It could be a bad sensor, a problem with any of the related wiring or even the computer itself.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
AirborneGeekRanger
New User
Jul 15, 2012, 1:54 PM
Post #8 of 9
(3867 views)
|
|
Re: 2005 Mitsubishi Lancer Ralliart
|
|
|
I Just replaced the Crankshaft Position Sensor and the problem is resolved. BTW, it was a Pain in the A$$. It resides behind the timing chain cover. Had to pull the passenger wheel, plastic shrouds, tensionor pully, static pully, harmonic balancer, and then finally the lower timing chain/belt cover.
Tools used:
10 through 16mm wrenches and sockets
Cheater Bar with 1/4 end (Used to put the Serpantine belt back on the tensionor)
Flat Tip Screw driver (Used to pop off the plastic plugs that holds the shrouds in place)
Small plyers
Jack
Lug Wrench
Jack Stand
Thanks to all who provided advice.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jul 15, 2012, 2:03 PM
Post #9 of 9
(3862 views)
|
|
Re: 2005 Mitsubishi Lancer Ralliart
|
|
|
LOL......... there are some a lot worse that that one.
Glad you got it resolved.
I will close this thread now to prevent spamming.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
