|
| | |
|
|
inSIDious
Novice
Jun 20, 2011, 6:17 AM
Post #1 of 17
(2384 views)
|
|
Alero 2.4 trouble
|
Sign In
|
|
I have an '01 Alero, 2.5, 5 speed. Engine starts right up, idles fine, but you when you attempt to drive the trouble starts... The engine can't rev passed 2,700 rpm's or so, and then it cuts out and sputters and drops back to 1500 rpm and will rev up to 300 and as soon as it hits 3k, dips to 1500.. i have no power and can't get the car above 35 mph at best.. can't get up hills, nothing. i pulled the whole intake side off the engine and everything seems to be in order there.. I heard that the pcm's tend to fail a lot or go berserk. I'm looking for a way to test the pcm at home, or reset it. Or some other ideas as to whet the problem may be? some things to check? it was running perfect, drove it about 50 miles, and then, while driving, started to lose power.. i could only get it up to 50-55, then only 40, and once the engine gets hot, only about 20-25 mph.
was also thinking maybe it jumped time.. but i'd really like to hope that's not the case..
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 20, 2011, 6:19 AM
Post #2 of 17
(2379 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
I would first test the fuel pressure using an accurate gauge.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
inSIDious
Novice
Jun 20, 2011, 8:31 AM
Post #3 of 17
(2362 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
checked it. came out to 47 psi.. i think that's normal or close to normal.. what should i try next?
|
|
| |
|
|
inSIDious
Novice
Jun 20, 2011, 8:44 AM
Post #4 of 17
(2360 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
i found a torn vacuum line on the intake side.. could that be the problem? it would be nice to find out it's a $2 line as opposed to a pain in the ass timing chain job.
|
|
| |
|
|
chickenhouse
Enthusiast
Jun 20, 2011, 2:37 PM
Post #5 of 17
(2350 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
Have you repaired it? Results?
|
|
| |
|
|
inSIDious
Novice
Jun 20, 2011, 3:04 PM
Post #6 of 17
(2342 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
replaced the vacuum line, notta. i'm gonna go ahead and cut off the catalyitic. exhaust flow seems week and superbly hot when on the gas.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 20, 2011, 3:05 PM
Post #7 of 17
(2339 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
If you have the $50K for the fine, go ahead and cut it off.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
chickenhouse
Enthusiast
Jun 20, 2011, 3:11 PM
Post #8 of 17
(2334 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
O K, humor me for a minute. Before you go cuttin stuff off for a trial & error situation, (there are tess to check convertor specs), when engine is running, in a clear area of the intake, push down on the intake and note engine speed. If it increases, may be a bad intake.
|
|
| |
|
|
inSIDious
Novice
Jun 20, 2011, 3:21 PM
Post #9 of 17
(2331 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
i'm not concerned about the fine.. if i cut it off, i'm going to slap a new one on tonight. i'm not stupid enough to go driving around that way. and what do you mean push down on the intake? i pulled the whole intake side off, less the throttle body, and nothing changed.
|
|
| |
|
|
inSIDious
Novice
Jun 20, 2011, 3:29 PM
Post #10 of 17
(2328 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
and online it says the fine is $2500, not $50,000. and the emissions parts on the vehicle are far passed their five year warranties, so legally, i can cut it off and eat the thing if i want to, i just can't drive without it.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 20, 2011, 3:41 PM
Post #11 of 17
(2323 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
Sure you can. you just have to put it back the way it was and depending who you are, the tampering fine can go a whole lot higher than $50K if you decide to modify it.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
chickenhouse
Enthusiast
Jun 20, 2011, 5:24 PM
Post #12 of 17
(2315 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
OK, stay on the fine thing if you want, I'm saying the intake on these go bad. If you can clear your mind, while it runs, find a clear spot where you won't hurt yourself, and push on the intake manifold- downward-if the rpm increases, MIGHT be a problem! Understand?
|
|
| |
|
|
inSIDious
Novice
Jun 20, 2011, 5:35 PM
Post #13 of 17
(2309 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
cut the cat, fired it up, and it redlines with ease. I'll check out the intake to be sure, but i think for now it's alright.
|
|
| |
|
|
chickenhouse
Enthusiast
Jun 20, 2011, 5:41 PM
Post #14 of 17
(2304 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
lucky shot. good 4 you.
|
|
| |
|
|
samg.
User
Jun 25, 2011, 7:55 AM
Post #15 of 17
(2284 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
Been at a gm store for 5 years and i've NEVER seen any problems related to the intake. Have you checked the press regulator? Is the ect reading normally?
|
|
| |
|
|
zmame
Veteran
/ Moderator
Jun 26, 2011, 7:38 AM
Post #16 of 17
(2270 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
FYI you can just remove the upstream O2 sensor to check for plugged cat you dont have to cut the old one off.
|
|
| |
|
|
chickenhouse
Enthusiast
Jun 26, 2011, 9:22 AM
Post #17 of 17
(2266 views)
|
|
Re: Alero 2.4 trouble
|
Sign In
|
|
I've never been at a GM store- found 2 of these in Arkansas, far from the wandering crowd. I guess no one can see them all!
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
