|
|
|
Ford Focus Hard to start.
|
|
|
| |
|
|
powerk
New User
Sep 23, 2012, 7:14 AM
Post #1 of 8
(20013 views)
|
|
Ford Focus Hard to start.
|
Sign In
|
|
Hello, I have a 2005 Ford Focus SE, 2.0 L, 72k Miles, About a month ago it started taking 7 secounds or more of cold cranking to start, hot it's fine, and once it starts it runs fine.
Thanks, Charlie
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Sep 23, 2012, 7:21 AM
Post #2 of 8
(20004 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
Check engine light on?
Fuel pressure drain back is one cause for delayed starting. Connect a fuel pressure gauge and look for fuel pressure bleed off when the fuel pump turns off.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
powerk
New User
Sep 23, 2012, 7:27 AM
Post #3 of 8
(19998 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
No lights on. If the preasure bleeds off would that be a fuel pump or is there a seperate regulator?
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Sep 23, 2012, 7:42 AM
Post #4 of 8
(19981 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
There is also a TSB out for your symptoms. Might be a good idea to perform the TSB first if the software isn't at that revision level.
TSB 06-8-14
05/01/06
HARD START/LONG CRANK
FORD:
2005 Focus
ISSUE
Some 2005 Focus 2.0L automatic transmission equipped vehicles may experience longer than expected cranking times followed by poor, rough run-up during a start procedure. If this condition only occurs intermittently, reprogram the powertrain control module (PCM).
ACTION
Reprogram the powertrain control module (PCM) to the latest calibration using WDS release B42.8 and higher or B43.1 and higher. This new calibration is not included in the B43 CD. Calibration files may also be obtained at the website.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
powerk
New User
Sep 23, 2012, 7:50 AM
Post #5 of 8
(19973 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
Would I have to take it to the dealer to check the upate or could, say, Advance Auto Parts check that for me?
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Sep 23, 2012, 8:00 AM
Post #6 of 8
(19963 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
You would have to take it to the dealer or a shop that has the capability of programming the computer in your vehicle.
Usually if there is a TSB and your symptoms match, the TSB should be performed first. I am not going to guarantee that is going to fix your problem. If it is a software bug though, replacing parts is going to be a waste of time.
The fuel system on your vehicle is returnless. If you have fuel pressure drain back, it could have a bad check valve in the fuel pump. Another possibility is a fuel injector leak. If there was an external leak, say fuel line, you would probably smell it and see gas puddles on the ground. To determine if you have an injector leak or fuel pump check valve leak, you would have to isolate them by using a shut off valve.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Sep 23, 2012, 8:01 AM)
|
|
| |
|
|
powerk
New User
Sep 23, 2012, 8:16 AM
Post #7 of 8
(19958 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
The problem just started, I'm thinking it's not the update. It doesn't start loaded up when hot, so sounds more like your first guess, fuel pump, I'm sure the pump is not serviceable, which means a assembly?
I will have to get my hands on a gauge and test pressure.
Thanks for your help.
Charlie
p.s. I will let you know.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Sep 23, 2012, 8:22 AM
Post #8 of 8
(19954 views)
|
|
Re: Ford Focus Hard to start.
|
Sign In
|
|
Aftermarket does sell the pump motor and strainer by themselves, so you don't have to replace the entire module. There is no factory service info on replacing just the motor, so can't tell you how well that works out.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
(This post was edited by Discretesignals on Sep 23, 2012, 8:24 AM)
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
