Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN






Only Starts With Fuel Pump Relay Pulled


Search for (search options)
 



PM5K
New User

Jun 2, 2007, 9:29 PM

Post #1 of 1 (1385 views)
Only Starts With Fuel Pump Relay Pulled Sign In

2002 Jeep Grand Cherokee Limited, 4.7L High Output V8

I can only get my Jeep to start by trying to start it a half dozen times or more, then pulling the fuel pump relay, then trying to start it a half dozen times again, once it starts I have someone put the fuel pump relay back in before it stalls out and the vehicle runs.

It does run rough and makes a tapping noise, sounds like a stuck or sticking lifter.

It will usually start back up if it's within twenty minutes, after that it doesn't.

I've checked fuel pressure, specs are 49.2 +/- 5 PSI.

I replaced the filter/regulator and prior to this pressure was 44 PSI, it's now 54 PSI. These are key on numbers, not engine running since it doesn't startup without the process I mentioned.

After I replaced the regulator it started up, it stumbled at first then got going, I could hear what sounded like a vacuum leak from the rear where the regulator/filter was at so I turned off the Jeep after about a minute or so, I found what I believe is a vacuum hose that had come off, I assume it's vacuum because it had no fluid in it, it's the line below the fuel line and goes torwards the fuel filler.

I put it back on but I can't get the Jeep to start again, seems to be the same as before.






 
 
 






Search for (options) Privacy Sitemap