|
|
Coloradomom
User
Oct 30, 2010, 7:11 PM
Post #1 of 5
(1379 views)
|
|
Replaced 5.7 engine
|
Sign In
|
|
Replaced 5.7 engine ,runs good ,but engine light stays on
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Oct 30, 2010, 7:14 PM
Post #2 of 5
(1372 views)
|
|
Re: Replaced 5.7 engine
|
Sign In
|
|
I'm assuming you replaced it with the exact same engine that came out of it.
The "check engine" light is an indicator for a system that monitors many electronic functions in the system, also called the "malfunction indicator lamp" (MIL). It can come on for any of hundreds of different causes from any of the systems that the computer monitors. Some are very important and can lead to further component or engine damage and some are emissions related not as serious but still a problem and need to be repaired.
Your first step is to have the computer scanned to retrieve the trouble codes that were set when the check engine light came on. Those codes will give you specific information about what the computer saw and will get you pointed in the right direction to find your problem. With a 1996 or newer and some 95 cars and you have an AutoZone or Advanced auto parts in your area, they will read them for free. Once you have these code numbers, we can be a lot more specific about what your problem may be.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Coloradomom
User
Oct 30, 2010, 7:20 PM
Post #3 of 5
(1365 views)
|
|
Re: Replaced 5.7 engine
|
Sign In
|
|
1993 GMC Suburban 5.7 motor replace with 1988 motor
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Oct 30, 2010, 7:31 PM
Post #4 of 5
(1359 views)
|
|
Re: Replaced 5.7 engine
|
Sign In
|
|
Diagnostic Trouble Codes - 1993
Chevrolet 13 Open Oxygen Sensor Circuit
14 Coolant Temperature Sensor (High Temp Indicated)
15 Coolant Temperature Sensor (Low Temp Indicated)
21 Throttle Position Sensor (Signal Voltage High)
22 Throttle Position Sensor (Signal Voltage Low)
23 Manifold Air Temperature (MAT) Low Temp Indicated
24 Vehicle Speed Sensor (VSS) Circuit
25 Manifold Air Temperature (MAT) High Temp Indicated
32 Exhaust Gas Recirculation (EGR) Circuit
33 Manifold Absolute Pressure Sensor Circuit (High Sig.)
34 Manifold Absolute Pressure Sensor Circuit (Low Sig.)
35 Idle Air Control (IAC) 41 Cylinder Select Error
42 Ignition Control (IC) Circuit
43 Knock Sensor (KS) Circuit
44 Oxygen Sensor Circuit (Lean Exhaust Indicated)
45 Oxygen Sensor Circuit (Rich Exhaust Indicated)
51 EEPROM or ECM Failure
53 System Voltage Overcharge
54 Fuel Pump Circuit (Low Voltage)
55 ECM Error 61 Degraded Oxygen Sensor
62 Transaxle Gear Switch Signal Circuit
63 A/C Refrigerant Pressure Sensor Circuit
To extract a trouble from the computer for diagnostic purposes, the Assembly Line Communication Link (ALDL) connector is used.
Ground terminals A and B with the ignition "ON" and engine not running. The system will enter the diagnostic mode. In this mode, the computer will display a 12, three consecutive times, by flashing the "CHECK ENGINE", "SERVICE ENGINE SOON" or "MALFUNCTION INDICATOR LAMP" or light. A 12 consists of one flash, a short pause, then two flashes in rapid succession.
After 12 is displayed, any stored trouble s will be displayed by flashing the "CHECK ENGINE", "SERVICE ENGINE SOON" or "MALFUNCTION INDICATOR LAMP" light. All s are displayed 3 times each then a 12 will repeat. In the diagnostic mode, the computer will also energize all computer controlled relays and solenoids. 
ALDL Connector (Located Underdash)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
(This post was edited by Hammer Time on Oct 30, 2010, 7:32 PM)
|
|
| |
|
|
Coloradomom
User
Nov 6, 2010, 7:35 PM
Post #5 of 5
(1333 views)
|
|
Re: Replaced 5.7 engine
|
Sign In
|
|
Thank you for the information,,
Code 33 34 check and replaced,and engine light stays off...
Thank you for the codes.
BR
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
