|
|
|
Stalling troubles in a 98 VW Beetle
|
|
|
| |
|
|
thebug87
New User
Mar 23, 2010, 11:15 AM
Post #1 of 4
(2956 views)
|
|
Stalling troubles in a 98 VW Beetle
|
Sign In
|
|
Three days ago my car started having some problems. I would be able to drive my car for about 15 minutes before it would shut off. I tried to restart the car and the engine turned over but wouldn't catch. After about 10 minutes the car started and I drove it home. I checked the oil level, air filter, fuses, and coolant. The following day I drove the car to my dad's and the same stalling issue occurred and it restarted after 10 minutes and I continued driving to my destination. At this point my car had about a little under half a tank of gas. We checked the vacuum in the gas tank, which seemed all right. I then drove the car for a while to make it stall, once stalled we turned the key and it would turn over, but, not catch. We then immediately opened the gas cap and the car turned over leading us to believe there is an issue with the vacuum in the fuel tank. We have since driven the car for over an hour and it has not stalled, however, the gas level is now lower than a quarter of a tank. So I am back to square one. The check engine light is always on in the car so I cannot tell if a sensor is bad.
The car had similar stalling issues two years ago and the crank sensor was replaced. Four years ago the oxygen sensor was replaced.
We are going to check the mass air flow sensor and lights. Any other suggestions would be greatly appreciated.
1998
Volkswagen Beetle
2.0 L
145,000 Miles
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 23, 2010, 11:30 AM
Post #2 of 4
(2954 views)
|
|
Re: Stalling troubles in a 98 VW Beetle
|
Sign In
|
|
With the CEL light lit there's a code or more to read for guidance on what the issue is. Get the code(s) -
T
|
|
| |
|
|
thebug87
New User
Mar 23, 2010, 11:36 AM
Post #3 of 4
(2949 views)
|
|
Re: Stalling troubles in a 98 VW Beetle
|
Sign In
|
|
Thanks for the advice, but, I am trying to avoid getting the codes read for two reasons: 1 - The light is always on because there is something wrong with the signal and 2 - I priced the dealership and cost is about 150 just to read the code.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Mar 23, 2010, 12:30 PM
Post #4 of 4
(2947 views)
|
|
Re: Stalling troubles in a 98 VW Beetle
|
Sign In
|
|
You shouldn't have to go to a dealer to get a comprehensive code reading. Many parts outlet do that for free to sell parts of course and they may not give a complete answer or have a good of equipment.
I know if it costs something it's still worth it as you have a problem and that could certainly help. Think - you could be saving a mega expensive repair to fix something now.
No harm in ruling out things you can see or find like things not attached properly, wiring plugs, vacuum hoses etc.
Tune and other maintenance needs to be up to date. It could just be getting bad info and trying to make adjustments and when it can't it will set a code,
T
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
