|
|
hodge
Anonymous Poster
hodg0899@yahoo.com
Jan 13, 2009, 6:53 PM
Post #1 of 7
(3734 views)
|
|
1991 maxima wont start
|
Sign In
|
|
1991 Nissan Maxima 200,000 miles. Car would crank and try to start but sputtered dead in less than a second. The starter was engaging but the car would not fire.
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jan 13, 2009, 7:18 PM
Post #2 of 7
(3731 views)
|
|
Re: 1991 maxima wont start
|
Sign In
|
|
Hodge; There are a kazillion causes of your symptom. We need to know if it's getting spark and/or fuel.
Nissans have problems with the coolant temp sensors (CTS). Check the connector at the sensor for a good, positive connnection and check it for corrosion, clean if needed. This could cause it to overfuel and 'flood' the engine. Timing belt, injector issues, fuel pump, ignition issues, ect. are all suspect at this point.
Loren
SW Washington
|
|
| |
|
|
Guest
Anonymous Poster
Jan 16, 2009, 7:14 PM
Post #3 of 7
(3722 views)
|
|
Re: 1991 maxima wont start
|
Sign In
|
|
I have now checked and the engine is not flooded or seized. The battery registers as good and the starter also. In chkecking the voltage at the starter with the car off there are 26.6volts this decreases to 4.6 when the engine is cranking. At the connection that runs the negative ground from the starter up to the relay and then to the positive cable I found 26.6 with car off and 26.6 when cranking I am not sure what this signifies if you could help me I was Also checking on A/C.
|
|
| |
|
|
Guest
Anonymous Poster
Jan 16, 2009, 7:18 PM
Post #4 of 7
(3717 views)
|
|
Re: 1991 maxima wont start
|
Sign In
|
|
Also the car will now not crank at all. So i am attempting to diagnose that problem first.
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jan 16, 2009, 7:47 PM
Post #5 of 7
(3709 views)
|
|
Re: 1991 maxima wont start
|
Sign In
|
|
26.6V? Whoa! We working on an airplane? A fully charged 12V battery has 13.2V (1.2V per cell). Regardless, if the voltage drops to 4V during crank, I'd say you've got a bum battery.
Loren
SW Washington
|
|
| |
|
|
Guest
Anonymous Poster
Jan 18, 2009, 1:46 PM
Post #6 of 7
(3704 views)
|
|
Re: 1991 maxima wont start
|
Sign In
|
|
it is 12.45 volts on the dc current. I wass checking on AC for some reason. I tried a different battery and it still will not try to crank. i tried to short the strater between the two post and it still will not crank. It seems to me it has a draw on the electricity when I try to crank. Any ideas on most likely causes for a draw. Also the starter directly goes from 12.45 to about 4 volts on cranking. The first resistor clip up from the starter has no change from the 12.45 volts does this mean it is bad?
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jan 18, 2009, 1:51 PM
Post #7 of 7
(3701 views)
|
|
Re: 1991 maxima wont start
|
Sign In
|
|
Don't even want to think this, but have you tried to turn the engine over by hand? It can be a bit of a pain to do, but there is a large bolt head on the crankshaft. With the key off, put a wrench or ratchet/socket, and try and turn the engine. If you can't turn it...well, you know the answer. If it turns, you're probably looking at a bad starter.
Loren
SW Washington
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
