|
|
Libraazzu
New User
Jun 18, 2010, 4:30 PM
Post #1 of 2
(2925 views)
|
|
1991 oldsmobile no fire
|
Sign In
|
|
I have a 91 oldsmoble cutlass ceria that wont start, it is getting gas, and the starter is good however there is no fire going to the engine. it was running just fine maybe a little on the rough side but I turned it off for a second and when i went to start it, my thumb slipped off of the key and it did not complete the start and when i attempted to start it again it would not start. I pulled a plug to see if there was fire and nothing...i have had this happen before and i would disconnect the battery and wait a few minuets and it would start, now nothing i had the crankcase sensor replaced a few week ago...could someone help
|
|
| |
|
|
Sidom
Veteran
/ Moderator
Jun 18, 2010, 8:55 PM
Post #2 of 2
(2918 views)
|
|
Re: 1991 oldsmobile no fire
|
Sign In
|
|
I'm assuming you meant crank sensor.
It's best to test spark with a spark tester and fuel with a gauge and noid light. Once your sure it's spark, you want to make sure the crank sensor is sending a out a good signal and the Ign module is recieving it, that module had power and ground.
A quick check would be to see it the engine is showing an rpm reading while cranking, if not you may have got a bad sensor....
You also want to check all the fuses as well......
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 