|
|
|
2004 pontiac grandam wont start
|
|
|
| |
|
|
nealdouglas
Novice
Jul 2, 2014, 5:49 AM
Post #1 of 14
(3086 views)
|
|
2004 pontiac grandam wont start
|
Sign In
|
|
2004 grand am wont start. starter kicks in but wont start sometimes it will start.then it goes back to just kicking in. w replaced the starter and the ignition switch .I turned the key on for ten minutes then turned it off and tried to start it. it started once then started just bumping again.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jul 2, 2014, 6:05 AM
Post #2 of 14
(3079 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
Have the battery tested to be sure it is good. Make sure your battery connections are clean and tight.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
nealdouglas
Novice
Jul 2, 2014, 6:11 AM
Post #3 of 14
(3074 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
I had the battery tested cleaned terminals even relocated the ground wire. but it didn't help.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jul 2, 2014, 6:19 AM
Post #4 of 14
(3070 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
Hmmm - moved ground wire? Where? Try using jumper cables to add ground to block and see if that helps assisting that wire which may be NG or the positive anywhere on route to starter,
T
|
|
| |
|
|
kev2
Veteran
Jul 2, 2014, 6:23 AM
Post #5 of 14
(3068 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
lets try to clear this up- some confusion as to cranking or not.
the starter works - engine cranks (spins) turns over but will not start?
Answer that - and let us know - easy just your observations -
1) is check engine light on?
2) is security light on?
3) is there a remote starter?
Can you use a test light? fuel pressure gauge? sheck for spark?
|
|
| |
|
|
nealdouglas
Novice
Jul 2, 2014, 11:28 AM
Post #6 of 14
(3044 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
ok tried using jumpers didn't help
|
|
| |
|
|
nealdouglas
Novice
Jul 2, 2014, 11:31 AM
Post #7 of 14
(3043 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
will the crank sensor cause this problem.
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Jul 2, 2014, 12:00 PM
Post #8 of 14
(3039 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
We need to know if this is a cranking problem (starter doesn't work) or a starting problem ( starter turns the engine, but the engine doesn't run).
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
nealdouglas
Novice
Jul 2, 2014, 11:44 PM
Post #9 of 14
(3020 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
starter kicks in but wont turn over new starter ignition switch and battery
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jul 2, 2014, 11:55 PM
Post #10 of 14
(3017 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
Please let's clear this up once and for all or we get no place. DOES THE ENGINE PHYSICALLY TURN AS IN BELTS MOVE AND IT SPINS BUT DOESN'T START OR NOT TURN (CRANK) AT ALL?
Saying "turn over" means nothing but used a lot for an engine that doesn't start for either reason. Approach is totally dependent on just what and how it fails,
T
|
|
| |
|
|
nealdouglas
Novice
Jul 4, 2014, 3:56 AM
Post #11 of 14
(2995 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
the starter engauges but the belts do not move
|
|
| |
|
|
nealdouglas
Novice
Jul 5, 2014, 5:22 AM
Post #13 of 14
(2968 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
the motor isnt seized if i jump it at the starter it turns over.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Jul 5, 2014, 5:37 AM
Post #14 of 14
(2965 views)
|
|
Re: 2004 pontiac grandam wont start
|
Sign In
|
|
You do mean jump to where pos cable goes to starter and ground to good known ground? If that always works your problem is cables and or connections. I could try to explain how to check for voltage dropping while starter tries and doesn't work but GM side post cables are notorious for being bad and good old lead and copper cables are gone now so can be weak inside insulation along the way - either pos or ground.
If you meant jumping the "trigger" wire that's another issue. Think about just getting new quality cables completely - I would. Problem just too annoying for this crap all the time so would be new and greased up to last and routed as intended originally,
T
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
