|
|
|
2013 Dodge Journey RT, won’t Crank over
|
|
|
| |
|
|
JourneyRT2013
Novice
Aug 7, 2018, 9:21 PM
Post #1 of 17
(2290 views)
|
2013 Dodge Journey RT, won’t Crank over
|
|
|
What could cause a 2013 Dodge Journey RT 3.6L AWD to one day be running fine no issues ever, to the gps starts by not working go to reset it by removing the negative terminal lead, when it’s reconnected the car will go through the process of starting but won’t, I can here a click inside of the car like a relay activating, but the starter does not try to crank at all. all the lights work except now the driver side light and passenger blinker stopped working as well. It has a new battery in it now to. Neutral start don’t work either I’ve even tried to jump it with no luck. Checked fuses even, the car also will say sometimes it’s not in park aswell. I was also told to remove both terminal leads directly from the battery and hold them together for a bit, which I left them off and touching for a couple hours. They did not touch any terminals on the battery, I was told that could reset the computer. I’m going to check the ground cables from the starter and alternator tomorrow as well. Any help would be great.
(This post was edited by JourneyRT2013 on Aug 7, 2018, 9:24 PM)
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 1:50 AM
Post #2 of 17
(2262 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
2013 model a new battery if original would be expected actually a while ago. Did the problems happen before that or from changing it? If you didn't charge new one first and have the car on "memory" saver you already lost all pre-set info and computer went brainless.
It's up to you to know any features this car has that automatically prevent it from starting aftermarket or from new may be at play?
Just because even if it speeds up pithing memory from items in the car don't touch battery terminals together! Just reset it with a code reader if you must lost memory just causes problems no telling what a dead short touching terminals can do!
Charge new batteries before installation and check that they are any good! Many are NOT they don't get a run thru before selling them and are NOT fully charged when you get it,
T
|
|
| |
|
|
Discretesignals
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 4:13 AM
Post #3 of 17
(2251 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
If the battery and connections are good, the next place to start is by doing a full system scan and looking at data pids that are important for it to crank.
Since we volunteer our time and knowledge, we ask for you to please follow up when a problem is resolved.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 7:41 AM
Post #5 of 17
(2232 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
That quote below now made my hair stand up. Good bet whatever the problem is or was that is now. Ha - Billy-Bob! LMAO,
TQuote
I was also told to remove both terminal leads directly from the battery and hold them together for a bit, which I left them off and touching for a couple hours. They did not touch any terminals on the battery, I was told that could reset the computer.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 7:46 AM
Post #6 of 17
(2226 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
Holding the cables together is acceptable and recommended. That uses up any power stored in capacitors in the system to truly clear the memory.
The whole point was clearing the memory without reading it first.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 8:34 AM
Post #7 of 17
(2217 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
Understood. I just turn on headlights or something the uses power if I wanted it "pithed" but the Chrysler products always scare me,
T
|
|
| |
|
|
JourneyRT2013
Novice
Aug 8, 2018, 9:44 AM
Post #8 of 17
(2206 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
The idea was not to short the system but to dissipate any additional stored charge to hopefully reset the computer. My understanding from researching this the last few nights seems to be a pretty common Chrysler issue, sigh. I just noticed a new symptom last night after posting this, my passenger taillight is now out aswell, I did not notice it befor but it more then likely happened when the other stuff did. I’m going to try and find a wiring diagram and trace them wire to there terminals and grounds. Hopefully it just ends up being a grounding issue.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 10:14 AM
Post #9 of 17
(2197 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
You need to stop disconnecting batteries. No good comes of that. NOTHING needs to be reset to resolve a problem. In fact you can cause a few new ones that can be quite costly to resolve.
I don't know how you could possibly relate a starting issue to a tail light out.
If you ever stop disconnecting the battery long enough, you might be able to read some trouble codes.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
JourneyRT2013
Novice
Aug 8, 2018, 10:16 AM
Post #10 of 17
(2193 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
There are no trouble codes and I have not disconnected the battery since I put a new one in, but apperantly these forums are more for criticism then help. Also with electrical and depending how the system is wired a bad ground or short somewhere can easily cause all these symptoms, I came on here in hopes of maybe someone had the same issue and it was something small or goofy because Chrysler is well known for crappy wiring.
(This post was edited by JourneyRT2013 on Aug 8, 2018, 10:18 AM)
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 10:24 AM
Post #11 of 17
(2185 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
Yes, we do point out self destruction.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 8, 2018, 10:29 AM
Post #12 of 17
(2181 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
No, Chrysler is not known for crappy wiring. You are listening to unknowledgeable car owners that are venting because that can't figure out their problems.
You aren't going to find people with the same problem here. This site is staffed with a very small number of professional technicians that help people for free.
If you don't like the advice you get here, you can request a refund and try another forum where all the car owners agree with you.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Charlymich
User
Aug 8, 2018, 7:29 PM
Post #13 of 17
(2155 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
Try making sure you have full battery voltage to your starter. Then do a voltage drop test from battery + to starter. Good place to start
|
|
| |
|
|
JourneyRT2013
Novice
Aug 9, 2018, 2:30 PM
Post #14 of 17
(2118 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
Try making sure you have full battery voltage to your starter. Then do a voltage drop test from battery + to starter. Good place to start
Thanks that’s what I am trying now, I managed to fix the headlight and blinker issue that ended up being a bad wire to the fuse box, I went out and bought a auto wire tracer detector.
I noticed the starter solenoid engages when I first try to start it, but after the first attempt it’s like there not enough voltage going to it, so I got under the car today and also noticed that not only is my starter in a horrible location lol, but the terminal connected to the solenoid is corroded and green, so when it stops finally storming I will start by cleaning that and then tracer the wire back making sure there are no shorts or breaks.
(This post was edited by JourneyRT2013 on Aug 9, 2018, 2:34 PM)
|
|
| |
|
| | |
|
|
JourneyRT2013
Novice
Aug 10, 2018, 7:06 PM
Post #16 of 17
(2046 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
Problem has been solved, after taking the starter out cleaning all the terminals, it ended up being the ground wire. Under the the electrical insulation where the wire is crimped to the contact, it was badly wired so I cut the wire and re crimped a new contact and it fixed the whole issue. The old contact look perfect almost new. Only reason I noticed it was because as I was holding the wire to reconnect it to the post it felt strange, like way to thin. This was not at the starter, it was at the main ground from the battery.
Thanks for the advice and help
(This post was edited by JourneyRT2013 on Aug 10, 2018, 7:08 PM)
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Aug 10, 2018, 7:13 PM
Post #17 of 17
(2040 views)
|
|
Re: 2013 Dodge Journey RT, won’t Crank over
|
|
|
OK, we can close this one now.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
