Main IndexAuto Repair Home Search Posts SEARCH
POSTS 		Who's Online WHO'S
ONLINE 		Log in LOG
IN




Automotive Repair
Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:   
  Login
  Sign up here!



90 ford tempo thermostat

Search for (search options)
 



Guest
Anonymous Poster
marisa.marco@comcast.net

Jan 21, 2009, 2:53 PM

Post #1 of 2 (4419 views)
90 ford tempo thermostat Sign In
I have a 90 Ford Tempo. How do I change the thermostat? And where is the thermostat?!!! I need all the details. I'm a girl. Please do not assume I know what I'm doing. Crazy


Tom Greenleaf
Ultimate Carjunky / Moderator
Tom Greenleaf profile image

Jan 21, 2009, 3:19 PM

Post #2 of 2 (4417 views)
Re: 90 ford tempo thermostat Sign In
If you don't have the tools and the place to do this it really shouldn't be that expensive to just have done and save the mess,

T

REMOVAL&INSTALLATION

REMOVAL & INSTALLATION

See Figures 1 through 6
When draining coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze, and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless it is contaminated or several years old.
  1. Disconnect the negative battery cable.
  2. Place protective covers on the front fenders.
  3. Drain the cooling system into a sealable container.
  4. Unplug the wire connector at the thermostat housing thermo-switch if equipped.
  5. Loosen the top radiator hose clamp. Remove the thermostat housing mounting bolts and lift up the housing. Remove the thermostat by turning counterclockwise.
  6. Clean the thermostat housing and engine gasket mounting surfaces.

To install:
  1. Install new mounting gasket and fully insert the thermostat to compress the gasket. Turn the thermostat clockwise to secure in housing.
  2. Position the housing onto the engine.Install radiator hose clamp and tighten to 20-30 inch lbs. (2.3-3.4 Nm). Install the mounting bolts and torque to 8-10 ft. lbs. (10-14 Nm).
  3. Refill the cooling system.
  4. Connect the negative battery cable, start the engine and check for leaks.
Fig. 1: Engine thermostat-2.0L engine Fig. 2: Engine thermostat-2.3L engine Fig. 3: Engine thermostat-3.0L engine Fig. 4: Remove the harness from the housing Fig. 5: With the retaining bolts removed, take the thermostat and housing out of the engine compartment, and place on a clean surface Fig. 6: Remove the thermostat from the housing. Remember the direction in which it was installed






 
 
 






Search for (options) Privacy Sitemap