Main IndexAuto Repair Home Search Posts SEARCH
POSTS 		Who's Online WHO'S
ONLINE 		Log in LOG
IN




Automotive Repair
Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:   
  Login
  Sign up here!



Latest Forum Post
with_replies.gif image   1989 toyota pickup 3.0 crank no start
I have a 1989 toyota pickup 3.0 crank no...

with_replies.gif image   Strut spring orientation and strut mount tension nut
2017 Nissan rogue awd 2.5 L Put in Monro...

with_replies.gif image   Transmission stuck in part, I have tried everything
So I'm working on my elderly fathers 201...

with_replies.gif image   2017 dodge journey LED headlights on/off randomly
Year of vehicle 2017 Make of vehicle dod...

with_replies.gif image   Kia Soul starter replacement issues!
Okay so my car is a 2010 Kia soul 2.0 en...

hot_with_replies.gif image   Please Help - Knock sound & engine fail
Hi all, Hoping to get some insight and ...

with_replies.gif image   multiple warning lights
2013 GMC Terrain 130,000 miles 4 cylinde...

with_replies.gif image   03 alero no low speed blower
Good day everyone, I have a 2003 Olds a...

with_replies.gif image   04 Chevy 2500hd tail light issues
Help!!! I have changed my combo switch...

with_replies.gif image   1999 Grand Caravan Sport not starting.
Hi. I'm new here. I hope someone can hel...




92 Cutlass Supreme Starting Problems: Please Help!!

Search for (search options)
 



aahawks
New User

Jun 15, 2006, 8:40 AM

Post #1 of 3 (2818 views)
92 Cutlass Supreme Starting Problems: Please Help!! Sign In
my mom has a 92 olds cutlass supremem 6 cyl. Her car will start only when it wants too and that is not very often. When it doesnt start, nothing happens when you turn the key except for clicking under the hood on the drivers side by the engine somewhere, not the starter. I took the starter off and had it checked, it was fine. I put it back on and the car started perfectly. I turned it off and tried to restart and it would not turn over at all. I thought that maybe the starter was going bad so I bought a new one just to test it with. I hooked it up and it also did not turn over. I put a test light up to the wiring on the starter and the test light came on when the key was turned. I dont think that the car has a starter relay? I thought that it might be the neutral safety switch, I think that it is located where I hear the ticking when the key it turned. I dont know what else to check, please help.


DanD
Veteran / Moderator
DanD profile image

Jun 15, 2006, 11:42 AM

Post #2 of 3 (2811 views)
Re: 92 Cutlass Supreme Starting Problems: Please Help!! Sign In
Here’s a few tests you could try; with a test light connected to ground and someone holding the key in the start position. The test light should light at the S terminal of the starter (purple wire). The way it sounds you’ve all ready did this and you have power getting to the solenoid. If so then the neutral safety switch is ok.
Next I would do voltage drop tests across the positive and negative cables.
Connect the voltmeter as I tried to show in the wiring diagram. The voltmeter will/should show zero volts; have someone turn the ignition to the start position and hold it there. You should see no more then .25 (decimal 25) of a volt. Any more then that you have an open in the cable or a bad connection.
For example, if you connect the voltmeter from battery positive to the starters main positive terminal, turn the ignition to the start position and have 4 volts showing. Look for corroded connections, if connections are clean and tight replace the cable. Same goes for the ground cable.
Dan.



Canadian "EH"






Guest
Anonymous Poster

Dec 30, 2006, 2:25 PM

Post #3 of 3 (2688 views)
Re: 92 Cutlass Supreme Starting Problems: Please Help!! Sign In
In Reply To
a possibility: i have a 91 supreme 6 cyl, that also has an 'intermittent' starting problem that sounds a lot like yours--if your mom has a tilt-steering wheel, the wire connections in the column can become worn/frayed from the adjusting movement. try turning the steering wheel a little when you turn the key. [also, check her ignition key--could be time to replace it if edges are worn, not making good contact].





 
 
 






Search for (options) Privacy Sitemap