|
|
|
98 civic smog test failure
|
|
|
| |
|
|
Guest
Anonymous Poster
j.coffey2@yahoo.com
Aug 20, 2009, 10:10 AM
Post #1 of 2
(3187 views)
|
|
98 civic smog test failure
|
Sign In
|
|
1.6L Manual Civic 1998 - 116K
I just moved to Cali, need to license my car for the first time. Before coming out, I had some work including timing belt replaced.
Upon arrival I had a smog test and failed. Had some more work done and failed.
First Test-
15 mph 1564 rpm
HC (max 64, ave 9, ME- 63)
CO% (max .55, ave .02, ME .27)
NO PPM (max 477, ave 57, ME 0388)
25 MPH 1820 RPM
HC (max 47, ave 7, ME 50) <-- FAIL
CO% (Max .54, ave .03, ME .77) <-- FAIL
NO (764, 50, 0392)
After the first test, my check engine light came on within a day of leaving, it had done this before. I had the oil changed, replaced my plugs, plug wires, and cap. I also added a fuel additive and put 91 octane gas in. I drove around for 20 min in the city before going to have test done. I had the test done in the early morning. My car did sit not used for about 20 min before he finished the test he was working on.
Second Test-
15 mph 1729 rpm
HC (max 64, ave 9, ME- 42)
CO% (max .55, ave .02, ME .32)
NO PPM (max 477, ave 57, ME 0370)
25 MPH 2730 RPM
HC (max 47, ave 7, ME 19)
CO% (Max .54, ave .03, ME .65) <-- FAIL
NO (764, 50, 0349)
The car is idling much better again. I knew my car was not running as well before and the gas mileage was down. Its clearly running much better but all the changes are costing me. I need to get this right.
Also, why would my rpm's at 25 mph go up to 2730 when the car is now firing better? What is causing my test failure. I'm sure my car is running well now, but need to pass this test. I'm shocked I'm coming in so much above the averages.
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Aug 20, 2009, 10:30 AM
Post #2 of 2
(3184 views)
|
|
Re: 98 civic smog test failure
|
Sign In
|
|
Well, CA is much stricter than WA. Not entirely certain, but it appears that you are failing CO at cruise speed. The CO readings at idle are higher than I'd like to see, but within limits, obviously. The rpm readings you mentioned could be the gear that it was tested in from test 1 to test 2? Several things can affect CO. Poor injector spray pattern, engine temperature, fauly injector, ect. If you haven't had an injector service (cleaning) done, that may help. And should be done, anyway, for maintenance reasons. Make sure that the engine is getting hot enough. A faulty, or missing, thermostat can cause this. Does CA use a dyno when testing, or just a two speeed static test? Also, check tire pressures if they are using a dyno. Low tire pressures can cause more resistance, and hence higher CO.
Loren
SW Washington
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 