|
|
|
Hyundai Elantra 2009 Stalling
|
|
|
| |
|
|
Psyfurius
User
Jun 17, 2021, 1:44 PM
Post #1 of 4
(1477 views)
|
|
Hyundai Elantra 2009 Stalling
|
Sign In
|
|
Hello. I recently bought a 2009 Hyundai Elantra, 2.0 liter, 4 cyl, with 140,000 miles.
The car sometimes lowers the revolutions when idle. Sometimes when I'm driving at 40 or 50 and brake at the stoplight, the revolutions goes under the 500 RPM's, stalls a little and comes up quickly.
I have changed the fuel filter, changed the mass air flow sensor, cleaned the throtle body, changed the Purge Valve, cleaned the injectors manually with the 9 volt battery and solvent method, changed the air filter, changed the spark plugs and the spark plug wires and I have made sure to disconnect the negative battery terminal before making any changes to the car.
Although this may not have to do with the problem, I also changed the solenoids and transmission hardness and flushed all the old oil and put in new oil. Also I did flushed the old coolant, cleaned all the hoses and installed a new thermostat.
The Check Engine light is off. I have an OBD2 scanner on hand. Maybe someone can tell me what else to check or troubleshoot with.
Thanks in advanced.
(This post was edited by Psyfurius on Jun 17, 2021, 1:56 PM)
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 17, 2021, 2:26 PM
Post #2 of 4
(1446 views)
|
|
Re: Hyundai Elantra 2009 Stalling
|
Sign In
|
|
If you have already cleaned the throttle body inside thoroughly and you have no air or vacuum leaks, then you likely need to replace the Idle Speed Control actuator.
Circled in the picture.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Psyfurius
User
Jun 17, 2021, 2:40 PM
Post #3 of 4
(1437 views)
|
|
Re: Hyundai Elantra 2009 Stalling
|
Sign In
|
|
Thanks! Now that you mentioned the Idle Air Control Valve, I remember taking it out and it was dirty and sticky inside. So I cleaned with carburetor cleaner spray and remove all the gunk. But… should I replaced it anyway?
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 17, 2021, 2:47 PM
Post #4 of 4
(1433 views)
|
|
Re: Hyundai Elantra 2009 Stalling
|
Sign In
|
|
Well, you still have a problem so you have to do something. Carb cleaner alone will leave it dry and not smooth. If you want to try something else first, take it out again and lube it up with some WD40 or other spray lube. If that doesn't work, replace it.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
Lukewarm Heat............
Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
1989 toyota pickup 3.0 crank no start
