Main IndexAuto Repair Home Search Posts SEARCH
POSTS
Who's Online WHO'S
ONLINE
Log in LOG
IN









Strut replacement


Search for (search options)
 



mmmmsass4
New User

Jun 24, 2016, 1:58 AM

Post #1 of 4 (1510 views)
  post locked   Strut replacement  

2007 Dodge Grand Caravan with 150,000 miles. Front passenger side strut repair. I purchased quik strut assemblies for the front end of my van. Drivers side was simple - removed entire strut as a unit and installed pre-assembled new strut. On passenger side, the shock is broken. The piston rod that goes up into the center of the upper strut mount and is secured by a nut has ripped out of the upper strut mount. Not the three little bolts the hold the strut mount in place, the main bolt the holds the strut assembly together. I can slide the shock piston up & down with my hand. The outer spring is still under tension. My question: Do I need to rent a spring compressor to safely remove the strut assembly from the vehicle? Will lifting the vehicle remove the tension from the spring since it is no longer held compressed by the shock nut?


Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Jun 24, 2016, 2:11 AM

Post #2 of 4 (1503 views)
  post locked   Re: Strut replacement  

You won't be able to lift the van enough to relieve the spring pressure. You will need a spring compressor. Either that of just cut the spring in half with a cut off wheel. Be careful doing that though as there will still be some tension on it when the cut goes through. Take as much weight off the spring as possible first.



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.



(This post was edited by Hammer Time on Jun 24, 2016, 2:12 AM)


mmmmsass4
New User

Jun 24, 2016, 2:27 PM

Post #3 of 4 (1488 views)
  post locked   Re: Strut replacement  

Update: Took your advice, jacked the van up high and cut the spring in half. It wasn't under too much pressure and dropped right out. Finished up the job, no problems. Thank You!!


Hammer Time
Ultimate Carjunky / Moderator
Hammer Time profile image

Jun 24, 2016, 2:56 PM

Post #4 of 4 (1484 views)
  post locked   Re: Strut replacement  

Glad to hear you got it resolved.

Closing this now as solved.



~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.







 
 
 






Search for (options) Privacy Sitemap