|
|
2000 Acura Integra GSR clutch problem.
|
|
|
| |
|
stewda
New User
Feb 2, 2008, 12:46 AM
Post #1 of 3
(2960 views)
|
2000 Acura Integra GSR clutch problem.
|
Sign In
|
|
Ok so I was driving down the road today, and there was no problems at, everything fine, i was heading into town with a friend and i got to a red light and pulled out of 5th gear and it wouldn't go into any gears after that. So I pulled it off to the side of road into a parking lot, turned it off, didn't help, I cranked it up and it wouldn't go into gear.... tried cranking it when in 1st gears and it jumped off the start with the clutch pushed in. So I turned it off, waited a min or two, cranked it up and then pushed(little force) into 1st, and it makes a horrible grinding sound. It like the gears are moving but nothing is catching.... If you happen to know what the cause or have an idea, please let me know! Thanks. Also it is an aftermarket ACT clutch if that helps any.
|
|
| |
|
stewda
New User
Feb 2, 2008, 6:44 PM
Post #2 of 3
(2950 views)
|
Re: 2000 Acura Integra GSR clutch problem.
|
Sign In
|
|
I got a friend to bring his trailor to come take it to his shop today, and i went to show him the problem and it actually went into gear.. i reversed it out of the drive way then could not put it into 1st or any gear, i then turned it off and could start it from 2nd gear.. So i got it into his shop and the oil was low.. i checked and found no leaks, but previously theplug was a little losose but didnt think much oil was lost from it. I then filled it up with oil and was able to drive it back to my house(not to far) and it looked up on me once.. It does when cranking up and putting it into 1st gear make a grinding sound like something is not catching... I have no idea what the problem is, but hopefully yall have more advice or i can get some from someone tomorrow.
|
|
| |
|
Tom Greenleaf
Ultimate Carjunky
/ Moderator
Feb 3, 2008, 3:57 AM
Post #3 of 3
(2948 views)
|
Re: 2000 Acura Integra GSR clutch problem.
|
Sign In
|
|
Doesn't this have a hydraulic clutch linkage? It might have leaked or isn't disengaging the clutch when pushed to floor. Sounds like that is the problem. They can fail without leaks at master or slave cylinder or leak at any point in either or along the way, T
|
|
| |
|