Main IndexAuto Repair Home Search Posts SEARCH
POSTS 		Who's Online WHO'S
ONLINE 		Log in LOG
IN




Automotive Repair
Car Troubleshooting Topics
  Car Troubleshooting
  Engine Troubleshooting
  Engine Fault Codes
  Electrical and Wiring
  Transmission Problems

Car Repair Topics
  Car Making Noises
  Car Stereo Repair
  Heating or AC Issues
  Motorcycles and ATVs
  Tricks of the Trade
  Truck Repair Advice

Site Options:   
  Login
  Sign up here!



Latest Forum Post
with_replies.gif image   Lukewarm Heat............
New antifreeze reverse flush heater core...

with_replies.gif image   multiple warning lights
2013 GMC Terrain 130,000 miles 4 cylinde...

with_replies.gif image   2014 Nissan Sentra Shaking
Car recently started shaking when accele...

no_replies.gif image   Buy Flualprazolam Powder Online Whatsapp: +1(424) 328-1086
N/A

hot_with_replies.gif image   1989 toyota pickup 3.0 crank no start
I have a 1989 toyota pickup 3.0 crank no...

with_replies.gif image   Strut spring orientation and strut mount tension nut
2017 Nissan rogue awd 2.5 L Put in Monro...

with_replies.gif image   Transmission stuck in part, I have tried everything
So I'm working on my elderly fathers 201...

with_replies.gif image   2017 dodge journey LED headlights on/off randomly
Year of vehicle 2017 Make of vehicle dod...

with_replies.gif image   Kia Soul starter replacement issues!
Okay so my car is a 2010 Kia soul 2.0 en...

hot_with_replies.gif image   Please Help - Knock sound & engine fail
Hi all, Hoping to get some insight and ...




Clutch wont engage when starting..

Search for (search options)
 



alternator81
New User

Dec 12, 2007, 9:35 AM

Post #1 of 4 (2106 views)
Clutch wont engage when starting.. Sign In
Hi everyone!

My problem is with my '94 Ford Ranger (manual). When I push on the clutch, the break pedal follows the clutch, like there is a loose screw holding them in place, so the clutch can't fully touch the floor. When starting it, I have to reach down and hold the break up with my hand while pushing on the clutch, then turn the key.

It was a really cold morning yesterday and stalled in morning traffic-- it was a nightmare! Has anyone heard of anything like this or have any ideas on how to fix it?


Tom Greenleaf
Ultimate Carjunky / Moderator
Tom Greenleaf profile image

Dec 12, 2007, 10:38 AM

Post #2 of 4 (2100 views)
Re: Clutch wont engage when starting.. Sign In
WELL ISN'T THAT SPECIAL!!Crazy Never heard of that one. Does this do the same with normal shifting? Only when starting for some reason??

Either way you have to get right under there and look right at where they mount and pivot to see just what's going on there.

Good luck with that one,

T



alternator81
New User

Dec 12, 2007, 10:55 AM

Post #3 of 4 (2097 views)
Re: Clutch wont engage when starting.. Sign In
No, it does not happen during normal shifting. What I mean is the clutch will engage when I drive, but it will not go far enough to the floor to start it. It's almost like what ever the two pedals are hooked onto is not stable, but moves. I have looked underneath but did not see anything. I will check again in a little while.


Tom Greenleaf
Ultimate Carjunky / Moderator
Tom Greenleaf profile image

Dec 12, 2007, 2:40 PM

Post #4 of 4 (2093 views)
Re: Clutch wont engage when starting.. Sign In
Whatever they are pivoting on is not stable as you said. This can't wait! That should be a very strong support under there where they mount. Sometimes you do have to screw around with them for switches for brakes and the clutch switch too - if they were ever replaced that could be a problem,

T






 
 
 






Search for (options) Privacy Sitemap