|
|
bill k
User
Jun 1, 2009, 11:49 AM
Post #1 of 10
(5379 views)
|
I have a 97 Jeep Grand Cherokee 4 x 4 limited with an auto tranny. I want to change the transmission filter. The manual I have says to adjust the bands while I have the pan off. The problem is the manual lists 5 diff auto tranny models. I looked at the id stamped in the side of my tranny and I do see any numbers close to the ones in the manual. the manual says there is a 42RE, 42RH, 44RE, 46RH and a 46RE and it lists all with the same torque values but different back off turn numbers once you reach that value. How can I determine which one I have?????
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jun 1, 2009, 5:40 PM
Post #2 of 10
(5372 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
bill k: Trans. band adjustments should be left for professionals, IMO. And, I'm NOT one. With that said, this is what I found:
According to what I found, it narrows it down to three possiblities; 42RE, 44RE, and 46RE. All three of these use the same spec; Kickdown: (with adapter) 47-50 inch lbs. (w/o adapter) 72 inch lbs.
Low/reverse: 72 inch lbs.
Again, I'd strongly advise having a transmission shop do these adjustments for you, assuming they are even needed. Band adjustment is critical.
Loren
SW Washington
|
|
| |
|
|
bill k
User
Jun 1, 2009, 6:22 PM
Post #3 of 10
(5368 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
Right out of the HAYNES MANUAL it says to adjust the bands when you change the filter, all adjustments are to 72 inch pounds, the diff is how far to back off the adjustemnt screw after you reach 72 inch pounds, the 42 RE says back off 3 5/8 turns, the 44 RE back off 2 1/4 turns, the 46 RE back off 2 7/8 turns. Sounds simple enough to me, the issue is to determine which tranny I have. The car has over 100K miles and when it sits for a day or two and I put it in gear it takes a few seconds before anything happens, then it moves slower then normal while the engine is reving up for another few seconds and then all is normal. I guess the fluid is crap and the bands must have some wear. and any tranny shop in S Florida is suspect. I took it to a jeep dealer a few years ago to have the fluid changed and they said the tranny needed an overhaul and I would be lucky if it got me home, that was about 30k miles ago.
|
|
| |
|
|
bill k
User
Jun 2, 2009, 10:27 AM
Post #4 of 10
(5359 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
My Handy Dandy Haynes Manual says I am to use MOPAR PLUS 4 ATF or equivalant tranny fluid. does any one know what the equivalent is?
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jun 2, 2009, 1:41 PM
Post #5 of 10
(5358 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
Bill; I know that CarQuest now carries ATF+4 now. Both my Dodges require it, too. It's cheaper than Mopar brand.
Loren
SW Washington
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jun 2, 2009, 3:54 PM
Post #6 of 10
(5356 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
Depending on which transmission you have, the specs call for DexII or ATF+3. You will be safe, either way, using ATF+4. Not worth taking a chance.
Loren
SW Washington
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 2, 2009, 4:45 PM
Post #7 of 10
(5353 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
The equivalent they refer to would be a synthetic that is compatible with virtually all fluids. That's what I use.
You can read about it here
www.amalie.com
Amalie Universal Synthetic Automatic Transmission Fluid is a full synthetic automatic transmission fluid with universal applications and is the newest and most dynamic member of Amalie's family of high performance automatic transmission fluids. Because it may be used in virtually every automatic transmission on the road today, including the new continuously variable transmissions (CVT) and those transmissions that require slip-lock fluid technology, this high quality product is the ATF inventory optimizer. It is a special blend of synthetic base oils coupled with a multi-functional additive system to provide unsurpassed protection and reliable performance for all types of automatic transmissions, power steering units and hydraulic systems manufactured by virtually all of the automotive and transmission manufacturers from around the world - the one fluid that replaces the confusion about which fluid to use in a multitude of automatic transmissions.Amalie Universal Synthetic Automatic Transmission Fluid is such a superior transmission fluid that it may be used wherever the better known fluids such as the General Motors approved Dexron¨ fluids including Dexron¨ III; the Ford Motor Company's Mercon¨ approved automatic transmission fluids including Mercon¨ V; the Chrysler approved fluids including the new ATF Plus + 4. Included in those transmissions that will operate at maximum performance on the new Amalie Universal Synthetic Automatic Transmission Fluid are those manufactured by BMW, Honda, Mercedes Benz (DaimlerChrysler), Mitsubishi and Toyota. This superior automatic transmission fluid is so good that we feel comfortable recommending it for use in any automatic transmission for any vehicle manufactured by American, European, Japanese, Korean and many other vehicle manufacturers around the world - it is truly universal and truly the one fluid you can use worldwide.Amalie Universal Synthetic Automatic Transmission Fluid is a premium multifunctional fluid that offers excellent year-round protection, superior high-temperature and low-temperature operation, enhanced CVT and slip-lock performance, better anti-shudder protection, long-life with extended-drain capabilities and is compatible with conventional automatic transmission fluids.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
|
Loren Champlain Sr
Veteran
/ Moderator
Jun 2, 2009, 5:18 PM
Post #8 of 10
(5347 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
>>This superior automatic transmission fluid is so good that we feel comfortable recommending it for use in any automatic transmission for any vehicle manufactured by American, European, Japanese, Korean and many other vehicle manufacturers around the world - it is truly universal and truly the one fluid you can use worldwide.<<
The 'we feel comfortable' part is what bothers me. Valvoline makes a trans. fluid called "MaxLife" that is 'supposed' to cover most all applications and they guarantee it, but I wouldn't put it in my vehicles. We don't do that many trans. flushes, but when it calls for special fluids, other than Mercon/Dexron III, to limit liability, we use what the manufacturer recommends. Can you spell paranoid? LOL. Personally, I've never had an automatic trans. fail. Shouldn't have said that. Darn. Regular maintenance is the key.
Loren
SW Washington
|
|
| |
|
|
Double J
Veteran
/ Moderator
Jun 2, 2009, 10:17 PM
Post #9 of 10
(5341 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
See if this helps you!
Click Here
|
|
| |
|
|
Hammer Time
Ultimate Carjunky
/ Moderator
Jun 3, 2009, 12:56 AM
Post #10 of 10
(5335 views)
|
|
Re: How to ID Tranny
|
Sign In
|
|
Amalie has a spec sheet and specific substitution list on their site.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
We offer help in answering questions, clarifying things or giving advice but we are not a substitute for an on-site inspection by a professional.
|
|
| |
|
Auto Repair Home
SEARCH
WHO'S 
LOG 
1989 toyota pickup 3.0 crank no start
Please Help - Knock sound & engine fail
