|
|
99 dodge 360 idle problem
|
|
|
| |
|
private pilot46
Anonymous Poster
Jul 11, 2008, 8:12 AM
Post #1 of 14
(4560 views)
|
99 dodge 360 idle problem
|
Sign In
|
|
to "way2old". waiting for truck to cool so i can check cool. temp. sensor. since the cool.temp. gauge is working normally, do you still think that is the problem? maybe there is a second sensor for the gauge and you are right.
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 11, 2008, 9:41 AM
Post #2 of 14
(4552 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
There are 2. One is the sensor(has 2 wires) which feeds computer. One is the sending unit(has one wire) which works the gauge. The one you want is buried down behind the alternator. Also, pleask keep your questions and replies under one thread. SO let's keep this one going and let the other 2 drop. OK??? Thanks. Being way2old is why I need help from younger minds
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 11, 2008, 3:59 PM
Post #4 of 14
(4540 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
I would replace the sensor. According to the chart below, the sensor starts reading at about 140 degrees. Being way2old is why I need help from younger minds
|
|
| |
|
private pilot46
Anonymous Poster
Jul 12, 2008, 6:58 AM
Post #5 of 14
(4535 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
please forgive my mistake in my last message. it should have said, after 4 hours sensor read 6.4k. now after sitting all night it reads 10.3k@74 degrees F air temp. don't give up on me.
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 12, 2008, 7:18 AM
Post #6 of 14
(4532 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
We won't give up until you do. Next time it is cooled off over night and you can get to it, pull a few plugs and see if there is any fuel on them. There3 may be a possibility the injectors may be leaking off causing a very rich statr up. Keep us informed. Being way2old is why I need help from younger minds
|
|
| |
|
privare pilot46
Anonymous Poster
Jul 12, 2008, 9:16 AM
Post #7 of 14
(4529 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
starting at the front of the engine on the pass. side, first plug was dry, second plug was damp, third was dry, fourth was damp.. on drivers side starting at the front, 5 was dry and 6 was dry. didn't check last two. all plugs were light tan,gap close to spec.. truck has 60k miles with original plugs,wires,rotor and cap. didn't suspect any of these since truck runs great once it starts warming up.
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 12, 2008, 5:53 PM
Post #8 of 14
(4521 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
You moight want to check the cap and rotor. They are in a hard place to get to. We have had Dodge products do crazy things due to ignition problems. If it is a 99 and has original ignition parts, they should be changed anyway(IMO). The cap could be condensating moisture from the heat after it cools down causing your problem. Being way2old is why I need help from younger minds
|
|
| |
|
private pilot46
Anonymous Poster
Jul 14, 2008, 7:35 AM
Post #9 of 14
(4517 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
new update on symtom. installed all new platinum plugs(same as old plugs). this time when i started truck i didn't touch gas until engine was up to temp.. the engine idled fine,but after revving engine in park several times, it started balking and running rough. it acted this way for 2-3 minutes then settled down and acted o.k.. when i drove it, it acted o,k.. this should rule out a problem with sensors,etc. that are part of the warmup cycle, right? do you still think cap or rotor could cause this?
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 14, 2008, 5:12 PM
Post #10 of 14
(4507 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
Is there anyway you can have a scanner put on the truck and look at the O2 sensors? Also look at the long term and short term fuel readings. Might be wise to have it taken to a shop and pay them about 1/2 hour labor to read the computer for you. Being way2old is why I need help from younger minds
|
|
| |
|
private pilot 46
Anonymous Poster
Jul 21, 2008, 5:12 PM
Post #11 of 14
(4497 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
got chilton manual for my truck from library and tested o2 sensor using it as a guide. found heater for sensor was not working. changed sensor and have had no problem since. your expert guidance was greatly appreciated. THANKS! pp46
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 21, 2008, 5:16 PM
Post #12 of 14
(4495 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
Thank you for the fix post. I can use that to get me a drink now. Being way2old is why I need help from younger minds
|
|
| |
|
Double J
Veteran
/ Moderator
Jul 23, 2008, 12:26 PM
Post #13 of 14
(4487 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
I think he's hoping someone will buy him a drink! Even tho I know its not my turn,Lord knows i'm way ahead... HERE W20...This one's for YOU! Congratulations on a job well done! Jim
|
|
| |
|
way2old
Veteran
/ Moderator
Jul 23, 2008, 4:45 PM
Post #14 of 14
(4483 views)
|
Re: 99 dodge 360 idle problem
|
Sign In
|
|
Why, thank you Jim. I will share one with you. Being way2old is why I need help from younger minds
|
|
| |
|